Coronary Stent (BMS)
pre-mounted on
rapid exchange PTCA
polyamide catheter

HELISTENT is a Bare Metal Stent (BMS) based on a unique helicoïdal design which has demonstrated its exceptional behaviour in terms of biomechanical characteristics.

Other coronary products:

TITAN 2

RAFALE

Clinical studies

A series of in-vitro and clinical trials have demonstrated the Helistent outstanding Biomechanical performances in terms of deliverability, trackability, ability to treat bifurcated lesions, safety in case of Direct Stenting and compatibility in 5F PCI procedures.

Technical specifications

Usable length: 140cm
Shaft diameter:
- Polytube 2.6F (0.87mm)
- Hypotube 1.9F (0.63mm)
Minimum guiding catheter:
- 5F (0.058" / 1.47mm)
Maximum guide wire diameter: 0.014" (0.356mm)
Radio-opaques markers:
One at each end of stent
Material composition:
316L stainless steel

5 REASONS TO CHOSE HELISTENT

1. Wedge strut

New Wedge Strut associated with Ultra Low Profile (≤1mm) for the HIGHEST POSSIBLE CROSSABILITY in tight lesions.

2. Flex Tip

New Flex Tip combined with unique Helicoidal Design for OPTIMAL TRACKABILITY even in the most tortuous arteries.

3. Balloon design

New balloon design offering mini shoulders (41° angulation) as well as short overhang (<0.5mm) for MINIMISED VESSEL INJURY during inflation.

4. Laser strut cutting

New laser strut cutting minimising metal amount in association with relatively low level of pro-inflammatory substances for BETTER CLINICAL OUTCOME.

5. Crimping process

New crimping process together with optimised balloon Burst Pressure allowing SAFE ACCESS AND DEPLOYMENT in all circumstances.

WebAnalytics solution by

Coronary Stent (BMS) pre-mounted on rapid exchange PTCA polyamide catheter